As an option, we offer the following

The above is a picture of the aeration/oxygen system. You can clearly see the air/oxygen enhancing pump on the plastic pedestal that slides over the pick-up tube. This system can increase the amount of bait being held in the tank by 40% or more.

    

Left picture is the air control center. A needle valve controls the amount of air/oxygen to the air/oxygen enhancer pump. This allows you to adjust the air flow as the smaller the bubbles the better. The right picture is the bottom side of air controller in the bait tank. The plastic tube transports air/oxygen to air enhancer pump.

    

Air/oxygen enhancer pump aimed to the side of the bait tank will control the current. This can be aimed in any direction in tank as shown in these pictures.

    

Air/oxygen enhancer pump system being placed into bait tank and view from bait well entrance.



This is all you have to do to install air controller in your existing Grayline Bait tank. Drill 1 ½ inch hole with flat spade bit, insert controller, hook plastic tubing to needle valve, and then to the base of air/oxygen enhancer pump.

    

To install air/oxygen enhancer pump simply remove the intake tube and slip the pedestal bracket over the intake tube. Then slide the bracket down the tube to the top of the skimmer and reconnect the tube to the filter box. Also, please note that the wires to this system will use the same path as the wires for the pump and filter basket.

GRAYLINE BAIT TANKS

CALL TO ORDER: George "Sunshine" Lening at
580-920-2085
OR
580-380-1187 (cell)
E-mail: baittanks@redriverok.com

We accept
---------------------------------------------banner heading below

Home                      Insulation   Filtration   Features   Aeration   Frequently Asked Questions

Instructions Oval Tank     Instructions Round Tank     Dealers   Supplies   Sizes/Prices   Sunshine Bait Tanks

---------------------------------------------banner heading above